BMComposites has recently expanded its in-house design team to 4 full-time Designers and Naval Engineers, over-seen by a management team of vastly experienced Technical Project Managers. Using the latest 3D CAD development software including Rhino, Solidworks and Autodesk, plus its in-house high-accuracy 3D scanning, the BMC Design Team is able to create virtually new structural and cosmetic carbon-fibre/composite components that can be visualised and tested prior to manufacture. The same 3D CAD data is then used to generate highly-accurate tooling in which the components are manufactured. The resulting parts require, if anything at all, a small amount of surface filling prior to painting, so vastly reducing weight and the costly fairing processes, which are required with aluminium fabrication. Additionally, by 3D scanning the yachts at the start of the project, the parts can be manufactured off-site and later delivered to locations all over Europe for rapid installation, without the need for hot works and often even painting on board.
With its in-house Design department, BMComposites is able to offer a truly one-stop-shop for fully-managed composites refit and repair programmes for the Superyacht industry.





